Commercial replacement
Replacement, re-cover or restoration — the answer is in the core cut.
Three genuinely different scopes at three very different prices. Which one your building needs depends on whether the insulation underneath is wet.
Start with what's under the membrane
The single most consequential thing about a commercial roof decision is the condition of the insulation. A sound, dry substrate opens up cheap options. A saturated one closes them, and anyone who tells you otherwise is selling you a problem you'll pay for twice.
Restoration or coating
Cheapest by a wide margin. A silicone or acrylic system over a sound membrane, adding 10 to 20 years and typically renewable. Only valid when the insulation is dry and the membrane is intact enough to bond to.
Re-cover
A new membrane installed over the existing one, usually with a cover board. Avoids tear-off cost and disposal. Code generally allows one re-cover, and only where the existing assembly is dry.
Full replacement
Tear-off to deck, new insulation to the R-value you want, new membrane. The most expensive and the only correct answer when insulation is wet, when there are already two roof systems, or when the deck itself needs attention.
We establish which of these applies with a moisture survey and core cuts, and we show you the cores. It's a five-minute conversation that decides a six-figure question.
How we keep buildings operating
- Work phased by roof section so no tenant loses access for long
- Nightly dry-in — no open deck when crews leave, ever
- Dock, delivery and trading schedules built into the sequence
- Interior protection over sensitive equipment and stock
- Crane and material staging planned with your site team in advance
- Daily progress photos and a written close-of-day status
Ask what the warranty requires of you
Most manufacturer NDL warranties on commercial systems require documented periodic maintenance. If nobody maintains the roof, the warranty quietly stops applying — usually discovered at the worst possible moment.
Choosing a system
| System | Service life | Strengths | Watch for |
|---|---|---|---|
| TPO | 20–30 yrs | Reflective, heat-welded seams, strong in Georgia sun | Weld quality is everything; needs a skilled crew |
| EPDM | 20–30 yrs | Long track record, very tolerant of movement | Black surface absorbs heat; adhered seams |
| Modified bitumen | 15–25 yrs | Tough underfoot, good for traffic areas | Heavier; torch application needs care |
| Metal restoration | 15–20 yrs added | Extends a sound metal roof cheaply | Only valid if the panels are structurally sound |
| Silicone coating | 10–20 yrs added | Lowest cost, minimal disruption | Requires dry insulation and a bondable surface |
Common questions
How much does commercial roofing cost per square foot?
Can you install over the existing roof?
What warranty is available?
Will you work nights and weekends?
Request your free inspection
Tell us about the property and we'll come out with a camera, a moisture meter and a written number.
Planning a capital roof project?
We'll survey, core test, and give you restoration, re-cover and replacement priced side by side.